Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Device works with interrup-
tions
Safety cutter bar (2) be-
comes hot.
Disposal/
environmental
protection
The device, accessories and packaging
should be properly recycled.
Electrical devices must not be dis-
posed of with domestic waste.
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at
the end of its useful life.
30
Possible cause
No mains power supply
Safety switch (4) or On/Off
switch (7) defective.
Worn out carbon brushes
Defective motor
Power cord (9) damaged
Internal loose contact
Safety switch (4) or On/Off
switch (7) defective.
Safety cutter bar (2) blunt
Nicks on safety cutter bar
(2).
Too much friction due to lack
of lubrication
Directive 2012/19/EU on waste
electrical and electronic equip-
ment:
Consumers are legally obliged to recycle
electrical and electronic equipment in
an environmentally sound manner at the
end of its life. In this way, environmentally
friendly and resource-saving recycling is
ensured.
Depending on the implementation in na-
tional law, you may have the following op-
tions:
• Return to a shop,
• Hand over to an official collection
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
Error correction
Check the socket, mains con-
nection cable, plug and fuse
and have them repaired by a
qualified electrician if neces-
sary.
contact the service centre.
contact the service centre.
Have the safety cutter bar
sharpened or replaced (ser-
vice centre)
Lubricate the safety cutter
bar (2)
point,
Publicidad
