Publicidad
Idiomas disponibles
Idiomas disponibles
7.
TROUBLESHOOTING
Problem
The display
remains off
The appliance is
overheating
Food is still raw
after cooking is
complete
The food is not
cooked evenly
Snacks are not
crispy
It is difficult to
slide the drawer
in
The appliance
produces
excessive smoke
and odours
Should any malfunctions other than those listed above occur, including the failure to
switch on the interior, or should an error code (E01 or E02) be displayed, a self-
sufficient solution is not feasible and the product must be inspected by a qualified
technician.
8.
TECHNICAL DATA
Power supply voltage
Maximum power
Gross drawer capacity
Possible cause
The power cord is
disconnected
The electrical outlet is
not powered
The rear ejection grille is
obstructed
Too much food has been
loaded
Insufficient cooking time
has been programmed
Too low a temperature
has been programmed
The spray function has
been activated too many
times
Stirring has not been
carried out as necessary
Snacks not suitable for
air cooking have been
cooked
The drawer is
overloaded
Too much greasy food
has been loaded
The heating elements
are dirty
: 220 – 240 V AC 50 Hz
: 1700 W
: 7L
Probable solution
Connect the power cord
Check the switches on the
Clean the grille or put the
appliance back in a free area
Divide the food into several parts
and continue cooking separately
Continue cooking at the same
temperature for a few minutes
Continue cooking for a short time
at a slightly higher temperature
Cook for a few minutes longer
without using the spray function
Take out the most cooked food
and briefly cook the remainder
Prepare snacks in a conventional
convection oven
Break up the food and carry out
several successive cooking steps
Stop cooking and check the food
Stop cooking and clean as
described in chapter 6
30
electrical panel
further
loaded
Publicidad
