Parkside PTHSA 20-Li C4 Traduccion Del Manual De Instrucciones Originale página 40

GB MT
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Device works with interrup-
tions
Safety cutter bar becomes
hot
Bad cutting results
40
Possible cause
Rechargeable battery (21)
not inserted
On/Off switch (13) is
broken
Rechargeable battery (21)
discharged
Defective motor
Internal loose contact
On/Off switch (13) is
broken
Safety cutter bar (1) blunt
Nicks on safety cutter bar (1) Check or replace the safety
Too much friction due to lack
of lubrication
Too much friction due to lack
of lubrication
dirty blade safety bar
Safety cutter bar (1) blunt
Bad cutting technique
Rechargeable battery (21)
discharged
Troubleshooting
Inserting the battery (Fig. E)
, p. 37
contact the service centre.
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)
contact the service centre.
contact the service centre.
contact the service centre.
Grind or replace the safety
cutter bar (1) (service centre)
cutter bar (1) (service centre)
Lubricate the safety cutter
bar (1)
Lubricate the safety cutter
bar (1)
Clean the safety cutter bar
(1)
Have the safety cutter bar
(1) sharpened or replaced
(service centre)
Working with the device,
p. 36
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)