Descargar Imprimir esta página

Parkside PFLB 30 A1 Traduccion Del Manual De Instrucciones Originale página 8

Cepillo plano

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
GB
MT
Technical data
Flat brush .....................PFLB 30 A1
Max. inlet temperature .....................60°C
Maximum working/
design pressure .......... 15 MPa / 150 bar
Designed for pressure washer
with max. pressure ...... 18 MPa / 180 bar
Compatible Parkside devices:
PHD 110, PHDS 110 Silent, PHD 135,
PHD 150, PHD 170, PHDM 110 Mini,
PHDP 180
Adapter (Accessories):
Maximum working/design
pressure .................... 15 MPa / 150 bar
Safety information
Symbols used in the
instructions
Hazard symbol with information on
damage prevention
Remove the mains plug
General safety instructions
• Pay attention at all times.
Pay attention, be aware of what you
are doing and take the utmost care
when working.
• Avoid abnormal body postures.
Ensure secure footing and keep your
balance at all times.
• Keep your work area tidy.
An untidy workplace can lead to acci-
dents.
8
• Wear suitable work clothing.
- When working outdoors, non-slip
footwear is recommended.
- Wear a hair net to contain long
hair.
• Consider environment influences.
Ensure the work area is adequately lit.
• Pressure washers can be dangerous
if used incorrectly. The jet must not be
directed at persons, animals, active
electrical equipment or the device itself.
• Take appropriate measures to keep chil-
dren away from the device.
• Please also note the safety information
of your pressure washer.
• Check whether you are permitted to
wash the car on the premises.
Assembly
Connecting without adapter:
1. Connect the flat brush (1) to the spray
gun of your PARKSIDE pressure washer
by inserting and screwing in (bayonet
locking device) the high-pressure con-
nection on the gun side.
Connecting with adapter:
1. Attach the adapter (2) to the high-pres-
sure connection and turn it through 90°
until it locks into place (bayonet locking
device).
2. Connect the spray gun of the pressure
washer (bayonet locking device) and
screw the coupling nut (3) of the ad-
apter (2) against the spray gun.
Test the flat brush (1) on all surfaces
in a non-visible location to ensure
compatibility.

Publicidad

loading

Este manual también es adecuado para:

440059 2304