Publicidad
Idiomas disponibles
Idiomas disponibles
WATER INDICATOR
When you open the battery cover, you will see a window under one battery for the water indicator.
You can use this viewing window to check whether the torque wrench has been damaged by
penetrating water. If it comes into contact with water, the window changes to red and the torque
wrench can no longer be used.
POWER ON THE WRENCH
Press the button
Usually press
ATTENTION: If an external force is applied to the torque wrench during power-on/reset or wake up
period, an initial torque offset will exist in the memory and the torque wrench must be reset ones
more.
ACTIVATION DURING SLEEP MODE
The wrench will auto sleep after about 5 minutes idle for power saving. Press
wrench during the sleep mode.
RESET
If the wrench does not function normally, press button
WHEN CHANGING THE TYPE OF HEAD
If you use different heads of the wrench, the reading on the display will be different for the different
length of the head.
Please refer to the following explanation:
D=D1x(L3+L1) / (L3+L2)
D: The set torque
D1: The actual torque applied to the nut
L1: The extended length
L2: The normal lenght
L3: The length from the fitting pin to the calibration point (C)
This torque wrench: L2 = 29 mm and L3 = 174.6 mm
PRE-SETTING
The memory locations 1 to 9 can be selected one after the other with the button
The display shows the selected memory location at the bottom right.
After memory location M9 is reached, the device jumps to memory location M1.
Note: If xEr
0x
of the specifications.
The memory for pre-settings has a maximum of 9 memory locations.
Memory location M1
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
to power on the digital torque wrench.
to reset the digital torque wrench before using it.
is appeared, that means this wrench has ever been applied more than 110% torque
Press
button
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
and
together to reset it.
Memory location M2
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
to wake up the
.
Press
button
Memory M3-M4 - - M9
Publicidad
