Publicidad
Idiomas disponibles
Idiomas disponibles
the storage box and become
inaccessible outside the door.
In this case, the ice storage box
needs to be cleaned and used
again.
•
As there is air in the water supply
waterway of the icemaker, the
water injection rate for the first ice
making may be low, resulting in
small ice cubes. However, during
the normal use of the icemaker,
the air in the pipeline will be
emptied.
Figure 2
NOTE
If the door is opened, ice or water cannot
be taken from the door.
To ensure hygiene, it is recommended to
pour out all the ice cubes made fully in
the ice storage box for the first time.
If slamming the door, it may cause the
water in the icemaker to splash into the
ice storage box.
To prevent the ice storage box from
accidentally falling, please operate with
both hands when disassembling the ice
storage box.
To avoid personal injury, please clean
up any water or ice that may fall on
the ground. To avoid possible injury to
children, do not allow children to touch
the ice fetching area or ice storage box.
Do not put your hands or any objects
into the ice outlet channel, otherwise,
it may cause personal injury or damage
to the parts of the ice storage box. To
avoid possible injury, do not touch the
ice outlet motor claw with your hands, as
shown in Figure 3.
The recommended external water
pressure for the ice maker is (0.25~0.42)
Mpa, and the nominal ice making capacity
is generally measured at 0.33Mpa. When
the water pressure is not within the
recommended range, the ice making
function is normal, but the ice making
volume will fluctuate, which is a normal
phenomenon.
If it is impossible to get ice from the
dispenser outside the door when the
ice storage box is full of ice, it may be
because the ice impeller is stuck by
ice. In such case, you need to manually
remove the stuck ice, and then the ice
can be taken normally.
Figure 3
Ice outlet motor claw
Ice outlet channel
23
V.1
Publicidad
