Publicidad
1
B
2
3
a
b
Caution:
Always make sure that the machine is unplugged from power
source and the main switch is on "O". when the machine is
not in use and before inserting or removing parts.
- This machine is equipped with a polarized plug which must
C
be used with an appropriate electrical outlet.
- Connect the machine to a power source as illustrated (1).
- The power switch is located above the terminal box. Your
machine will not operate unless this switch is on " I ". (1)
- Sewing light turns on automatically when the main switch is
on " I ".
- To start the machine, press on the foot control (2). The
speed of the machine is regulated by the amount of
A
pressure exerted on the foot control.
Attention:
Consult a qualified electrician if in doubt as to connect
machine to power source. Unplug power cord when machine
is not in use.
The appliance must be used with the foot controller 4C-316B
(110-120V area)/ 4C-326G (230V area)/ 4C-316C or 4C-
326C (220-240V area) manufactured by MATSUSHITA
ELECTRIC (TAIWAN) CO., LTD.
IMPORTANT NOTICE
For appliance with a polarized plug (one blade is wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If it does not
fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do
not modify the plug in any way. (3)
a. Polarized attachment plug
b. Conductor intended to be grounded
6
https://manual-hub.com/
Connecting machine to power source
Publicidad
