Publicidad
Idiomas disponibles
Idiomas disponibles
Pointek CLS200/300 (Standard)
Note: Pointek CLS200/300 is to be used only in the manner outlined in this manual, otherwise
protection provided by the equipment may be impaired.
This product is intended for use in industrial areas. Operation of this equipment in a
residential area may cause interference to several frequency based communications.
Standard version
lid without window
device
nameplate
Process connections
Compact (std.) configuration
Sanitary configuration
Cable and slide coupling
configuration
Ambient Conditions
• general applications
• in potential explosive
atmospheres
Process Conditions
Please see full Operating Instructions for Process Pressure/Temperature De-rating
Note:
Curves.
• relative dielectric constant (
• CLS200 temperature
- without thermal isolator–40 to +85 °C (–40 to +185 °F)
- with thermal isolator
• CLS200 pressure (vessel):
- rod version
- cable version
1.
At process connection.
Page EN-4
Pointek CLS200/300 (Standard) – QUICK START MANUAL
Pointek CLS200/300 is a versatile capacitance switch
with a high level of chemical resistance; ideal for level
detection of interfaces, solids, liquids, slurries, and
foam, and for simple pump control.
Approvals (verify against device
nameplate)
•CE, CSA
•Vlarem II, WHG
•Lloyd's Register of Shipping, categories ENV1, ENV2,
and ENV5
Note: The use of approved watertight conduit hubs/glands is req
Type 6 / NEMA 6, IP68 (outdoor applications). For CE requirement
cable entries is required.
R ¾", 1", 1 1/4", 1 ½" BSPT; ¾", 1", 1 1/4", 1 ½" NPT; G ¾", 1",
1 ½" BSPP
1", 1 ½", 2", 2 ½"and 3" tri-clamp
R ¾", 1", 1 1/4", 1 ½" BSPT; ¾", 1", 1 1/4", 1 ½" NPT (Taper);
G ¾", 1", 1 ½" BSPP
–40 to +85 °C (–40 to +185 °F)
check temperature class shown on device nameplate
1.5 minimum
r
1
:
–40 to +125 °C (–40 to +257 °F)
0 to 25 bar, gauge/365 psi, gauge/2500 kPa, gauge (nominal)
0 to 10 bar, gauge/150 psi, gauge/1000 kPa, gauge (nominal)
, FM, ATEX, INMETRO
C/US
A5E32221251
Publicidad
