Publicidad
Idiomas disponibles
Idiomas disponibles
2. Wash out the moistening brushes in soap or mild
detergent and place both brushes into the tank so
the angle on the brushes slopes toward the rear of
the tank. (See Figure 6)
Figure 6
3. Insert the tank into the opening on the front of the
machine, ensuring the tank is behind the upward lip
on the tank shelf.
4. Fill the bottle with water and place in the bottle
holder so the spout of the bottle is in the tank.
5. Adjust the roll guides for proper width of tape.
6. To load tape, take the roll of tape and peel off
about 18". Place the roll of tape in the basket so
that the strip of tape unwinds off the rear of the roll
as the leading end is brought towards the front of
the machine with the gummed side down. Thread
the tape over the black roller at the upper rear and
slide leading edge forward under the upper tape
plate and feed wheel. Close front and rear covers.
(See Figures 7a-7b)
Figure 7a
Figure 7b
Black
Roller
Tape
PAGE 3 OF 15
SETUP CONTINUED
ADJUSTMENTS
TAPE WIDTH
The adjustable roll guides in the tape basket should be
properly set for the width of tape being dispensed. The
roll of tape should be centered between the frames
by threading the tape loosely between the roll guides,
which engage in slots in the basket and roll guide
separator.
To set the roll guides in position, lift them out of the slots
in the basket and tie rod. Slide to the desired position
and drop guides into slots in the bottom of the basket.
(See Figure 8)
WATER LEVEL ADJUSTMENT
The amount of water required for proper moistening
of different grades of tape will differ. Heavier glues
or reinforced tapes will normally require higher levels
of water. Water level is controlled by the water level
adjustment screw located in the projecting portion of
the water tank. (See Figure 9)
To raise the water level, turn the screw counterclockwise.
To decrease the water level, turn the screw clockwise.
Figure 8
Slots
Roll Guide
Figure 9
Water Level
Adjustment
Screw
0724 IH-35
Publicidad
