Uline 333 PLUS Manual Del Usuario página 4

REPEAT LENGTH STOP
The unit is equipped with a feed stop. To set for desired
length, pull outwardly on the feed stop until the pin
disengages the hole in the drum skirt. Then slide the
feed stop assembly until the length desired is set on the
scale just above the feed stop assembly. Release the
knob, being sure the pin on the feed stop engages with
the proper hole in the skirt. (See Figure 10)
CRANK HANDLE
If desired, the crank handle can be reversed.
MAINTENANCE
The best way to ensure long and carefree service from
this dispenser is to keep it clean. Tape dust, adhesive
accumulation and other foreign matters are harmful as
they get into the working parts of the machine. Likewise,
be sure to wash the brushes thoroughly at least once
a week to ensure perfect moistening, being careful to
replace them with the lower bevel to the back of the
machine.
TO CLEAN BLADE
Where reinforced tapes are used, it may be necessary
to periodically clean accumulation of laminate from the
cutting blade.
To clean the blade, follow these steps:
a. Remove water bottle and water tank assemblies.
PAGE 4 OF 15
SETUP CONTINUED
SETUP CONTINUED
Drum
Skirt
Hole
Feed
Stop
Figure 10
MAINTENANCE AND CARE
PRESSURE PLATE WEIGHTS
The pressure plate, which rests on top of the brushes, has
removable weights. (See Figure 11)
The number of weights can be varied to suit the tape
being dispensed. Heavyweight tapes require more
weight inserts than lighter tapes. The suggested number of
weights is as follows:
35 lb. Kraft Tape
60 lb. Kraft Tape
Reinforced Tape
The weights can be added or removed by pushing
them in or out from each side.
NOTE: If the machine consistently jams, too
much weight is on the pressure plate and some
should be removed.
b. Depress rocker stop rod protruding from the right
side of the machine with right hand and keep
it in this position until the blade assembly has
been released. (See Figure 12)
Figure 12
Rocker
Stop
Figure 11
Weights
0 to 1 Slug
1 to 2 Slugs
2 to 3 Slugs
0724 IH-35