Publicidad
Idiomas disponibles
Idiomas disponibles
c. Reach inside the machine where tank was
removed, pull blade assembly down and swing
out to cleaning position. (See Figure 13)
d. To clean blade: wipe off with suitable solvent.
When adhesive is removed, wipe with lightly
oiled cloth.
PAGE 5 OF 15
MAINTENANCE AND CARE CONTINUED
Blade
Assembly
Figure 13
NOTE: Do not scrape with hard objects, as
resulting scratches will quickly accumulate
adhesive.
e. Reinsert the blade to the cutting position by
depressing the rocker stop rod. Tip the blade
up into cutting position and push upward so the
blade will come between the stationary blade
rollers. Release rocker stop rod.
f. Try feeding and cutting tape to check if parts
are in proper position.
g. Install tank and water bottle.
1-800-295-5510
uline.com
0724 IH-35
Publicidad
