cecotec BOLERO FLUX DT 606500 GLASS BLACK A Manual De Instrucciones página 51

- To facilitate air outlet, the ventilation duct should have a curvature of ≥120° and should be
connected to the outside wall.
- After installation, ensure that the kitchen hood is level to prevent grease build-up on the
end (Fig. 3).
Figure 4 shows the necessary elements to install the kitchen hood, bracket, and hooks.
Fig. 4 key:
1. Interior chimney bracket
2. External chimney bracket
3. Wall hook
1. The kitchen hood should be placed at a distance of 65-75 cm above the cooking surface for
best effect. Fig. 5.
2. Install the wall hook in a suitable location once the installation height is set and keep it
aligned. Use the screws to fix it to the wall. Fig. 6.
Fig. 6 key:
A.- Interior chimney bracket
B.- Wall hook
3. Fix the outer bracket on the chimney, and make sure that the inner part of the chimney can
be adjusted to the installation height, as well as that of the flexible connection pipe. Then,
install the flexible connection pipe in the chimney of the kitchen hood and place the hood
in the bracket. Fig. 7
Fig. 7 key:
A. Flexible connection pipe
B. Inside of the chimney
C. Bracket
D. Outside of the chimney
4. Place the kitchen hood on the hook on the wall. Fig. 8
5. Fix the outer bracket with the hooks and the inner part of the chimney with two screws
(ST4*8 mm). Fix the housing with safety screws (ST4*30 mm). Fig. 9
Please note
There are two safety ventilation ducts in the back housing.
4. OPERATION
When the kitchen hood is switched on, the power icon indicator light is red.
Power icon
- Press the power icon, the kitchen hood will beep, and all icons will light up, indicating that
the kitchen hood is in standby mode.
BOLERO FLUX DT 606500 GLASS BLACK A / BOLERO FLUX DT 906500 GLASS BLACK A
ENGLISH
51