cecotec BOLERO FLUX DT 606500 GLASS BLACK A Manual De Instrucciones página 54

ENGLISH
- It is recommended to check the condition of carbon filters regularly, at least two or three
times a year. Its replacement will depend on how the kitchen hood is used, as well as the
daily operating time.
- In case of very frequent frying, shorten the time interval for checking and/or replacing the
carbon filters.
Replacing the light bulb/lamp
Please note:
- The light bulb must be replaced by the official Cecotec Technical Support Service or
similarly qualified technicians.
- Always disconnect the power supply before performing any operation on the appliance.
When handling the bulb, make sure that it has cooled down completely before any direct
contact with your hands.
- When handling the bulbs, hold them with a cloth or gloves to prevent sweat from coming
into contact with the bulb, as this may reduce the bulb life.
Note:
- Before changing the light bulb, make sure that the appliance is switched off and unplugged.
- Protect yourself from danger when changing the light bulb, e.g., by wearing gloves.
6. TROUBLESHOOTING
Fault
The indicator
light is on, but the
motor does not
work
54
BOLERO FLUX DT 606500 GLASS BLACK A / BOLERO FLUX DT 906500 GLASS BLACK A
Cause
The kitchen hood is
obstructed.
The condenser is damaged.
Motor is jammed or bearing
damaged.
Motor is burnt or gives off a
bad smell.
Solution
Remove what is obstructing the hood.
Please contact the official Cecotec
Technical Support Service to replace
the condenser.
Please contact the official Cecotec
Technical Support Service to replace
the motor.
Please contact the official Cecotec
Technical Support Service to replace
the motor.