Ferve F-9050 Manual De Instrucciones página 4

1. Position the AC and DC cables so the hood, doors and other parts that may move or
produce heat do not damage them.
2. Determine which of the battery terminals is connected to the chassis.
2.1 Negative terminal connected to the chassis (like in most vehicles).
Connect the POSITIVE clamp (red) to the POSITIVE terminal (POS, +).
Connect the NEGATIVE clamp (black) to the vehicle chassis or cylinder block.
2.2 Positive terminal connected to the chassis.
Connect the NEGATIVE clamp (black) to the NEGATIVE terminal (NEG, -).
Connect the POSITIVE clamp (red) to the vehicle chassis or cylinder block.
3. Connect the AC power cable to the AC power cord connector
socket.
4. Turn on FERVE F-9050 by pressing the "ON/OFF"
5. Charger operation:
MANUAL XX AMP
MANUAL XX AMP
Select RESET to restart
CHARGING STAGE / ??%
STOP / RESET
Select STOP / RESET to restart
6. When the display indicates "MAINT/100%", the battery is fully charged.
7. Disconnect FERVE F-9050 in reverse order of the connection process: First turn off
FERVE F-9050 at the ON/OFF
remove the clamps.
4
CHARGER MODE
1. POWER SUPPLY
2. CHARGER
BAT TYPE SELECT
XXXXXXX
BATTERY CAPACITY
XX CCA
FAST XX AMP
NORMAL XX AMP
START
RESET
??%
xxx.x VOL / xx.x AMP
STOP / RESET
4 switch, disconnect the AC power cable and, finally,
and to the electrical
5
4 button.
Function selection
Battery type selection:
(AGM FLAT PLATE, AGM SPIRAL,
VRLA/GEL, REGULAR LIQUID)
Input capacity:
100CCA to 2,000CCA
Note: This information is indicated
on the battery
FAST XX AMP
NORMAL XX AMP
(FAST / NORMAL / MANUAL)
When choosing FAST o NORMAL,
the charging process is automatic
Input charging current
Note: The recommended
charging current is 10% of the battery capacity.
Example: 120Ah battery - 12 AMP
recommended charging current
Selection:
(START / RESET)
Show charging info:
DESUL: Desulfation
FSTCHR: Fast charge
ABSORB: Absorption
EQUAL: Equalization
FINCHR: End of charge
MAINT: Maintenance
Charging mode
selection