Roborock S8 MaxV Ultra Manual Del Usuario página 12

3. Add Device
Open the Roborock app, tap the "Scan to
Connect" or "Search for Device" button and
add your device following the in-app guide.
Notes:
The actual process may vary due to ongoing app
updates. Follow the guide provided in the app.
Only 2.4 GHz WiFi is supported.
If the robot waits more than 30 minutes for a
connection, WiFi will be automatically disabled. If you
want to reconnect, reset the WiFi before proceeding.
Instructions for Use
C
Adding the Cleaning Solution
C1-1— Remove the dust container cover,
pull out the entire cleaning solution
cartridge by its bottom handle, and
then place it on a hard, flat surface.
Note: To prevent the dust container cover from falling
and hitting the robot, remove the cover with both
hands, one on each side.
C1-2— Open the lid of the cartridge and
add cleaning solution.
C1-3— Close the lid and put the cartridge back
to the dock. Press down the cartridge
until you hear it lock with a click.
C1-4— Install the dust container cover in place
to make sure the dust container is
securely sealed.
Notes:
Make sure that the cleaning solution cartridge is
entirely removed before adding cleaning solution.
To prevent corrosion or damage, do not use
any disinfectant and only use cleaning solution
recommended by Roborock in the solution cartridge.
Cleaning solution is not included in the package.
Purchase one if needed.
Filling/Draining
During operation, the dock will automatically
fill and drain water.
Turning On/Off
Press and hold to turn on the robot. The
power indicator light will come on, and the
robot will be on standby.
Press and hold the button to turn off the
robot and complete the cleaning cycle.
Note: The robot cannot be turned off when it is being
charged.
Starting Cleaning
Press to start cleaning. The robot will
plan its cleaning route and in each room, it
firstly draws out zone edges and then fills
the room in a zigzag pattern. In so doing,
the robot cleans all rooms one by one,
thoroughly and efficiently.
Zone 1 – Cleaned Zone 2 – Cleaned
Zone 4 – Next Zone Zone 3 – In Progress
12
Notes:
To make sure the robot returns to the dock
automatically, start the robot from the dock and do
not move the dock during cleaning.
Cleaning cannot start if the battery level is too low.
Allow the robot to charge before starting a cleanup.
If cleaning is completed in less than 10 minutes, the
robot will clean the area twice.
If the battery runs low during a cleaning cycle, the
robot will automatically return to the dock. After
charging, the robot will resume where it left off.
The robot will retract the mop cloth mounts to clean
the carpet. You can also set the carpet as a no-go
zone in the app to avoid it.
Before starting each cleaning task, make sure that the
mop cloths have been properly installed.
Spot Cleaning
Press and simultaneously to start spot
cleaning.
Cleaning range: The robot cleans a 1.5 m
(4.9 ft) × 1.5 m (4.9 ft) square area centered
on itself.
Note: After spot cleaning, the robot will automatically
return to the starting point and be on standby.
Mop Only
Press to start Mop Only. The main brushes
rise, the main brushes and fan stop operating,
and the VibraRise module lowers.
Note: Compared with the traditional cleaning mode,
noise emanating from Mop Only is much lower.
Pause
When the robot is running, press any button
to pause it, press to resume cleaning,
press to send it back to the dock, and