Roborock S8 MaxV Ultra Manual Del Usuario página 16

Note: Make sure the disposable dust bag is properly
installed to avoid waste escaping and damaging the
dock.
D15-4— Install the dust container cover
in place to make sure the dust
container is securely sealed.
Removing Water Pipes
D16-1— Disconnect the power and water
supply. Pull out the lock plate at the
connection.
D16-2— Hold the snap ring at the
connection to remove the two
pipes one by one.
Notes:
When disconnecting the water pipes, use a container
to capture the flowing water and avoid wetting the
floor.
Avoid forcibly pulling out the water pipes, or the
product may be damaged.
Draining the Remaining Water
To transport or mail the product, empty
the remaining fluid in the dock using the
app. At the same time, empty and rinse the
cleaning solution cartridge, leave it to air
dry completely and then reinstall it.
Battery
The robot is equipped with a built-in high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Note: If the robot will be left unused for a long period,
turn it off and charge it at least every three months to
avoid battery damage caused by overdischarge.
Environment
Protection Information
Removing the Battery
* The following information applies only when
disposing of the robot and should not be followed for
day-to-day operations.
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Remove
the battery before disposing of this product
and hand it to a professional battery
recycling facility for centralized disposal.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the latch to pull out the battery
connector and remove the battery.
Notes:
Before removing the battery, make sure it is fully
drained. Do not attempt to remove the battery if the
robot is connected to the dock.
Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage
of hazardous substances.
In the event of accidental contact with battery fluid,
rinse thoroughly with water and seek immediate
medical care.
16
Basic Parameters
Robot
Model S82USV
14.4V/5200mAh (TYP)
Battery
lithium-ion battery
Rated Input 20V 1.5A
Charging Time Approx. 4 hours
Note: The serial number is on a sticker on the underside
of the robot.
Empty Wash Fill Dock Auto
Model EWFD14LRR
Rated Input Voltage 120V~
Rated Frequency 60Hz
Rated Input
6A
(Dust collection)
Rated Input
(Hot water mop 12A
washing)
Rated Input
1.35A
(Charging & drying)
Rated Output 20V
14.4V/5200mAh (TYP)
Charging Battery
lithium-ion battery
Maximum Water
0.4Mpa
Inlet Pressure
Minimum Water
0.1Mpa
Inlet Pressure
1.5A