Roborock S8 MaxV Ultra Manual Del Usuario página 13

press and hold to wash the mop cloths
and then resume cleaning.
Note: Placing a paused robot on the dock manually will
end the current cleanup.
Sleep
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
light will flash every few seconds. Press any
button to wake the robot up.
Notes:
The robot will not go to sleep when it is charging.
The robot will automatically shut down if left sleep for
more than 12 hours.
Washing the Mop Cloths
During cleaning, the robot automatically
determines when it should return to the dock
for mop washing and water tank refilling
to maximize its mopping performance. To
manually start washing, press and hold
or tap the corresponding button in the app.
Press any button to stop washing.
Notes:
To make sure the robot to wash the mop cloths
automatically, start the robot from the dock and do
not move the dock during cleaning.
Mop wash frequency and mode can be modified in
the app.
To avoid burns from hot water, do not touch the water
outlets.
Emptying
After cleaning, the robot will return to
the dock and auto-emptying will begin
as needed. To manually start emptying,
press on the docked robot or tap the
corresponding button in the app. Press any
button to stop emptying.
Notes:
When emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
Auto-emptying can be disabled in the app.
Avoid frequent manual emptying.
Drying
Drying starts automatically after mop
washing or after cleaning is completed.
To manually start or stop drying, tap the
corresponding button in the app.
Notes:
Stay away from the drying air outlets during drying.
Drying duration can be modified in the app.
Auto-drying can be disabled in the app.
Auto Cleaning Solution Addition
The robot will automatically add cleaning
solution to the water for mop washing and
robot water tank refilling according to the
preset ratio to ensure optimal mopping
performance.
Note: Smart Cleaning Solution Filling can be disabled
in the app.
Charging
After cleaning, the robot will automatically
return to the dock to charge.
13
Press to send the paused robot back
to the dock. The power indicator light will
breathe during robot charging.
Note: If the robot fails to find the dock, it will automatically
return to its starting position. Place the robot on the
dock manually to recharge.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period, or set whether to enable auto top-
up, emptying and drying, to dim the button
light, or lower the volume of the voice
message during the DND period.
Child Lock
Press and hold to enable/disable Child
Lock. You can also set it in the app. Once
enabled, the robot will not react to button
presses when it is stationary. When the
robot is cleaning or docking, press any
button to pause it.
Error
If an error occurs, the power indicator light
on the robot will flash red or status indicator
light on the dock will be steady red. A pop-
up notification will appear in the app and a
voice alert may sound.
Notes:
The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.