Safety Information
WARNING
For use only with roborock EWFD13LRR or EWFD14LRR charger.
To prevent injury caused by blades used to cut hair inside the main brush cover, make sure to install two main brushes in
place before installing the main brush cover.
The product must be switched off and the plug must be removed from socket outlet when not in use, before cleaning or
maintaining the product.
Connect to a properly grounded outlet only. See Grounding Instructions.
Old hose-sets should not be reused. Only use new pipes provided with this product or recommended by Roborock.
Place the dock in a dry place. Keep it a distance of more than 1.2m (4 ft) from baths and shower heads or isolate it with
walls or a door to prevent the dock from moisture exposure.
Install the dock in compliance with local regulations.
Do not move a properly installed dock.
Do not rinse the robot and the dock.
CAUTION
Only use the product in accordance with the User Manual. Any loss or damage caused by improper use will be borne by
the user.
Roborock assumes responsibility only for losses resulting from installation performed by authorized Roborock technicians,
excluding losses arising from incorrect installation by other people.
Before installing/removing the dock and its pipes, make sure the dock is disconnected from the power source.
Make sure dustbin, washable filter, dust bag, side brush, mop cloth, main brushes and main brush cover are installed in
place before cleaning.
Do not sit or stand on the robot or dock.
To prevent corrosion or damage, do not use any disinfectant and only use cleaning solution recommended by Roborock in
the solution cartridge.
Do not put any low objects (such as shoes, mats) near raised areas like stairs. Otherwise, the robot may fall down caused
by malfunctional sensors.
To prevent water damage, make sure that the floor where the robot operates is free of water.
Place the cords from other appliances out of the area to be cleaned.
Do not operate the vacuum in a room where an infant or child is sleeping.
04