Publicidad
Idiomas disponibles
Idiomas disponibles
General Power Tool Safety Warnings
6. Service
a. Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
Wait for the cutter to stop before setting
the tool down. An exposed rotating cutter
may engage the surface leading to possible
loss of control and serious injury.
Secure the material being planed. Never
hold it in your hand or across legs. Small
workpiece must be adequately secured so
that the rotating planer blades will not pick
it up during forward motion of the planer.
Unstable support can cause the blades to
bind causing loss of control and injury.
Always start the planer before blade is in
contact with the workpiece and allow the
blade to come to full speed. Tool can vi-
brate or chatter if blade speed is too slow at
beginning of cut and possibly kickback.
Check the workpiece for nails. If there are
nails, either remove or set them well be-
low the intended finished surface. If the
planer blades strike objects like nails it may
cause the tool to kickback and serious per-
sonal injury may result.
Disconnect battery pack from tool before
making any assembly, adjustments or
changing accessories. Such preventive safe-
ty measures reduce the risk of starting the
tool accidentally.
After changing blades, rotate the blade
cylinder (cutter drum) to make sure blades
are not hitting any part of the blade head
housing and the blade locking screws are
tight. Spinning blades could strike tool
housing and damage the tool as well as
cause personal injury.
Safety Rules for Cordless Planers
Additional Safety Warnings
SAVE THESE INSTRUCTIONS
ensure that the safety of the power tool
is maintained.
b. Never service damaged battery packs.
Service of battery packs should only
be performed by the manufacturer or
authorized service providers.
Use clamps or another practical way to se-
cure and support the workpiece to a stable
platform. Holding the workpiece by your
hand or against the body leaves it unstable
and may lead to loss of control.
Always hold the tool firmly with both
hands. This provides maximum control for
the operator.
Never pull the planer backward over the
workpiece. Loss of control may occur.
Do not put fingers or any objects into the
shavings exhaust port or clean out shav-
ings while tool is running. Contact with
blade drum will cause injury.
Disconnect battery pack from tool if it be-
comes necessary to remove shavings. The
blades are hidden from view and you may be
cut if blade is contacted.
GFCI and personal protection devices like
electrician's rubber gloves and footwear
will further enhance your personal safety.
Develop a periodic maintenance schedule
for your tool. When cleaning a tool be care-
ful not to disassemble any portion of the
tool since internal wires may be misplaced
or pinched or safety guard return springs
may be improperly mounted. Certain clean-
ing agents such as gasoline, carbon tetra-
chloride, ammonia, etc. may damage plastic
parts.
Ensure the switch is in the off position be-
fore inserting battery pack. Inserting the
battery pack into power tools that have the
switch on invites accidents.
5
Publicidad
