Balluff BNI XG1-505-0A5-K083 Manual De Instrucciones página 23

BNI XG1-505-0A5-K08 _
Network interface
1
User instructions for this guide
1.1 Validity
This guide provides all necessary information for the safe
use of the following IO-Link masters:
– BNI XG1-505-0A5-K083
Order code: BNI00HP
Connection of power supply: M12 A-coded
– BNI XG1-505-0A5-K084
Order code: BNI00HR
Connection of power supply: M12 L-coded
Read this guide and the other applicable documents
completely before installing and operating the product.
Original User's guide
This guide was created in German. Other language
versions are translations of this guide.
© Copyright 2024, Balluff GmbH
All contents are protected by copyright. All rights reserved,
including the rights of reproduction, distribution,
processing and translation.
1.2 Other applicable documents
Additional information about this product can be found at
www.balluff.com on the product page, e.g. in the
following documents:
– Data sheet
– Declaration of Conformity
– Disposal
1.3 Symbols and conventions
Individual instructions are indicated by a preceding
triangle.
► Instruction
Action sequences are numbered consecutively:
1. Instruction 1
2. Instruction 2
Numbers unless otherwise indicated are decimals
(e.g. 23). Hexadecimal numbers are represented with a
preceding 0x (e.g. 0x12AB).
Buttons or selectable menu entries are described in italic
and small caps, e.g. S .
ave
Menu commands are joined with a greater-than sign,
e.g. "S > O " stands for the menu command
ettingS ptiOnS
Options from the Settings menu.
Note, tip
This symbol indicates general notes.
www.balluff.com
1.4 Explanation of the warnings
Always observe the warnings in this guide and the
measures described to avoid hazards.
The warnings used here contain various signal words and
are structured as follows:
SIGNAL WORD
Type and source of the hazard
Consequences if not complied with
► Measures to avoid hazards
The individual signal words mean:
NOTICE
Identifies a danger that could damage or destroy the
product.
DANGER
The general warning symbol in conjunction with the
signal word DANGER identifies a hazard which, if not
avoided, will certainly result in death or serious injury.
1.5 Technical terms and abbreviations used
C/Q Switching and communication line
EMC Electromagnetic compatibility
FE Functional earth
GND Electrical ground, 0 V
I/O Standard inputs and outputs
n. c. Not connected
US Sensor supply
1.6 Pictures
Product views and pictures in these operating instructions
may differ from the specified product.
english 5