Balluff BNI XG1-505-0A5-K083 Manual De Instrucciones página 27

BNI XG1-505-0A5-K08 _
Network interface
4
Product description (continued)
4.3 Display elements
2D-Code
POWER IN
XD1
SF RUN
US
MOD
ERR
BF
NET
Status LEDs
MAC-ID
00-19-31-XX-XX-XX
XF2
XF1
ACT
LINK
BNI XXX-XXX-XXX-XXX
BNIXXXX
X01 X02
Port/Pin LEDs:
DI
Status of the IO-Link
and I/O ports
X03 X04
DI
X05 X06
Fig. 4-3: Display elements
DI
Port/Pin LEDs
– LED IO-Link – Port Pin 4
X07 X08
– LED DI – Port Pin 2
DI
Port/Pin LEDs Standard Port
Signal Meaning
Off State of input or output pins is 0.
Yellow State of input pins is 1.
Yellow State of input or output pins 4 is 1.
Both LEDs Short circuit of sensor supply between
red flashing pin 1 and pin 3
Red Short circuit at output on pin 4 against
pin 3
Red Short circuit at output on pin 4 against
pin 1
Red No high signal at diagnostic input
Red Current of pin 1, 2 or 4 is lower than
specified.
Red 24 V input signal on configured output
(actuator warning)
Tab. 4-1: LEDs Standard Port
www.balluff.com
Port/Pin LEDs IO-Link Port
Signal Meaning
Green IO-Link connection active
Green No IO-Link connection or incorrect
flashing IO-Link device
Green, fast IO-Link: Preoperate during data storage
flashing
Red, fast Validation failed / incorrect configuration
flashing of the IO-Link data length
Red, fast Data storage failed / incorrect device for
flashing data storage
Red IO-Link: Short circuit of pin 4 against
pin 3
Tab. 4-2: LEDs IO-Link Port
Status LEDs
Profinet communication
LED Signal Meaning
US Green Input voltage OK
Red flashing Input voltage low (< 18 V)
Red Shutdown mode or overvoltage
SF Off No error
Red Watchdog timeout; channel,
general or extended diagnostics
present; system error
Red flashing DCP signal service started via
bus.
BF Off No error
Red Low speed of physical link; or no
physical link
Red flashing No data exchange or no
configuration
ACT Off No data transfer and data
reception
Yellow, Send and receive data with
flashing connected device.
LINK Off Ethernet connection is not yet
established.
Green Ethernet connection established
with another device.
Tab. 4-3: Status LEDs – Profinet communication
english 9