Hkoenig kub14 Manual De Instrucciones página 10

ICE FULL: Ice full alarm indicator light
ADD WATER: Water shortage alarm indicator light
LARGE: Large ice indicator light
SMALL: Small ice indicator light
1. Plug in power, the machine is in standby mode, and the small ice indicator
light flashes green. Press the START/PAUSE button, the indicator lights of
small ice and large ice flash alternately, and enter the ice cube size selection
mode. When the corresponding indicator lights up, press the START/PAUSE
button again, and the machine starts to work. The corresponding indicator lights
up for a long time, and the ice cube production starts. After the ice making is
completed, the ice is shedded, and the machine enters the deicing function, and
so on.
2. CLEANING FUNCTION: Plug in power, press the START/PAUSE button to
start the machine, and then press the START/PAUSE button for 2 seconds.
The machine enters the cleaning function, and the four lights flash alternately.
Do not disconnect the power supply during cleaning. After cleaning, the machine
will automatically enter the standby mode.
3. ADD WATER: water shortage alarm: when the light is on, it means water
shortage in the water tank. You need to add water and press the START/
PAUSE button to restart the machine.
4. ICE FULL: ice full alarm. When the ice reaches the maximum amount of
ice storage container, the "ICE FULL" indicator light is on and the machine
stops. At this time, the ice needs to be poured out. When the ice position is
lower than the full sensor position, the machine will restart automatically.