Installation
Instalación / Installation /
Installation / Installazione
2.
Using an HDMI 2.0 cable (such as P569-XXX-CERT or P568-XXX-2A Series
cables), connect the HDMI source to the INPUT port on the local transmitter.
3.
(Optional) Using an HDMI 2.0 cable (such as P569-XXX-CERT or P568-XXX-2A
Series cables), connect a local monitor to the LOCAL port on the B127E-1A1-
HH local transmitter. Monitors with varying resolutions such as 4K 30Hz or
1080p can be connected without affecting the 4K 60Hz signal transmission.
4.
Using Cat6 cable up to 328 ft. (100 m), connect the RJ45 port on the local
transmitter to the RJ45 port on the remote receiver.
5.
Using an HDMI 2.0 cable (such as P569-XXX-CERT or P568-XXX-2A Series
cables), connect the remote receiver's HDMI port to a monitor.
6.
Turn the power ON to your connected displays. The LOCAL (orange) LED will
illuminate to indicate the local port has been connected to a display.
7.
Connect the external power supply to the local transmitter, and plug it into an
available wall outlet, Surge Protector, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The POWER (green) LED on the local
transmitter will illuminate to indicate the unit is receiving power from the
external power supply. The POWER (green) LED on the remote receiver will
illuminate to indicate the unit is receiving power from the local transmitter
through PoC technology.
8.
Turn ON the power to the HDMI source. The TX (orange) LED on the local
transmitter illuminates to indicate a signal is being received from the source.
The RX (orange) LED on the receiver illuminates to indicate a signal is being
received from the source to the display.
3