Publicidad
Idiomas disponibles
Idiomas disponibles
Control Panel
A
B
C
G
H
I
J
D
E
F
iiliii!j_
iii ii; _
et
t
K
L
M
N
The control panel isdesigned for ease in programming. The displaywindow on the control shows time of day, timer and oven functions.
Control panel shown includes Convect and other model specific features. (Styling may vary depending on model.:)
B
D:
H
Niij
Nii!ii!i!ii!il
Bake
Broil
Clean
Delay
Number Pads
Autoset
Keep Warm
Convect
Cook & Hold
Favorite
Timer
Clock
Oven Light
CANCEL
Use for baking and roasting.
Use for broiling and top browning.
Use to set self-clean cycle.
Programs the oven to start baking at
a later time.
Use to set time and temperature.
Use to quickly set temperatures.
Use to keep cooked food warm in oven.
Use for convection baking and
roasting.
Bakes for a preset time, then holds
food warm for 1 hour.
Use to set and save a specific
Cook & Hold procedure.
Sets Timer.
Use to set time of day clock.
Use to turn the oven light on or off.
Cancels all operations except Timer
and Clock.
Using the Touchpads
• Press the desired pad.
• Press the number pads to enter time or temperature.
• Press the Autoset 0 pad to enter temperature.
• A beep will sound when any pad is touched.
• A double beep will sound if a programming error occurs.
Note: Four seconds after pressing the number pads or
the Autoset 0 pad, the time or temperature will automati-
cally be entered. If more than 30 seconds elapse between
touching a function pad and the number pads or the
Autoset 0 pad, the function will be canceled and the
display will return to the previous display.
Clock
The clock can be set to display time in a 12-hour or 24-hour
format. The clock is set at the factory for the 12-hour format.
To change
the
clock
to 24=hour
format:
1. Press and hold the CANCEL and Favorite pads _,
for three seconds.
_(r
A__'r_
• 12 Hr flashes in the display
_/
_
L
2. Press the Autoset 0 pad to select 24 Hr;
press again to select 12 Hr.
3. Set the time of day following the directions in
the Toset the Clock section.
N
U
To set the Clock:
Au[oset
1. Press the Clock pad.
• The time of day flashes in the display.
2. Press the appropriate number pads to set the
time of day.
° Colon flashes in the display.
3. Press the Clock pad again or wait four seconds.
° The colon will remain on.
When electrical power is supplied or after a power interruption,
the last clock time before power was interrupted will flash.
11
Publicidad
