Cooper Lighting Solutions LD4 Instrucciones De Instalación página 3

Installation Instructions – LD4/LD6 Commercial Recessed LED Rough-In
Luminaire Quick
Disconnect
LED Engine
Trim
Assembly
Figure 5
LED Engine
Trim
Assembly
Figure 6
Figure 7
Figure 8
Installation Instructions – LD4/LD6 Commercial Recessed LED Rough-In www.cooperlighting.com
Torsion
Springs
Figure 9
5. If the LED modules has 2 or 3 LEDs, gently remove the
upper reflector by disengaging the white plastic latches
(Figure 25 & Figure 26) and discard it. Retain the upper
reflector on the trim for 1LED modules.
6. If the LED modules has Beam Forming optic, (Figure
16) gently remove the upper reflector and lens by
disengaging the white plastic latches (Figure 25 &
Torsion
Figure 26) and discard them.
Springs
7 . Insert LED engine on to trim assembly. Align post on
LED engine with slot on trim assembly (Figure 5.).
Note: Beam forming modules with optics do not have
wet location approval since the lens has to be removed
from the trim.
8. Rotate side clips (3) into place to securely attach trim
assembly to LED engine (Figure 9.).
Side Clips
9. Trim ring (optional) should be placed between the
ceiling and lower trim.
10. Properly align the connector as shown in (Figure 10).
Plug in the luminaire quick disconnect on the module.
11. Ensure the connector is properly engaged. (Figure 11).
12. Install the LED engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing (Figure 12).
Figure 10
3