Cooper Lighting Solutions LD4 Instrucciones De Instalación página 5

Installation Instructions – LD4/LD6 Commercial Recessed LED Rough-In
follow steps in "Optic Assembly Replacement/
Installation "(Figure 22 & 24)
8. To adjust the orientation of the asymmetric film, hold
the label tab and rotate it to required position. (Figure
23)
9. When the direction of the distribution is correct remove
the label. (Figure 24)
(Discard
when using 2.5" MEDIA 2
1 media)
MEDIA 2 HOLDER
2.5" MEDIA 1
MEDIA 1 HOLDER
Figure 17
Figure 18
Step for 2 Media
Notch in Optic Assembly
Figure 19
Figure 20
Installation Instructions – LD4/LD6 Commercial Recessed LED Rough-In www.cooperlighting.com
OPTIC
ASSEMBLY
2 MEDIA
ASSEMBLY
Optic Assembly
Asymmetric Film or
Diffuser Film
Asymmetric Film or
diffuser film holder
Step for 1
Media or
Asymmetry
Film or
Diffuser Film
Asymmetric Film or Diffuser Film with Optic
Figure 21
Finished
Assembly Media
Lens
Figure 22
Hold the label here
to adjust the
orientations of film
Figure 23
5