Cooper Lighting Solutions LD4 Instrucciones De Instalación página 4

Installation Instructions – LD4/LD6 Commercial Recessed LED Rough-In
Figure 11
Figure 12
Wall Wash Option
1. For wall wash option install frame with junction box
toward wall. (Figure 13)
2. For wall wash option install trim assembly with gradient
kicker opposite wall to be illuminated. (Figure 14)
Option 1
Wall
Figure 13
Gradient
Kicker
Figure 14
4 Installation Instructions – LD4/LD6 Commercial Recessed LED Rough-In www.cooperlighting.com
Option 2
Wall
Insert
Wall
Optic Assembly Replacement/Installation
1. Remove optic assembly from protective packaging.
2. Remove LED engine from protective packaging.
3. Insert optic assembly into LED engine holder and
align it with opening slots on the LED engine's holder.
(Figure 15)
4. Fasten optic assembly with LED Light Engine by gently
twisting clockwise until it stops. (Figure 16) Ensure the
optic is secured in place.
5. To replace optic from led light engine, twist optic
counter clockwise and take it out.
LED Engine
LED Engine
Optic Assembly
Optic Assembly
Figure 15
Figure 16
Optic and Media Assembly
1. Remove optic assembly from protective packaging.
2. Remove media holders from accessory packaging.
3. Insert media into the holder, if using only one media
discard the second media holder ring. (Figure 17)
4. Insert media assembly by aligning the media holder tab
with the notch in the optic assembly. (Figure 19)
5. Engage snaps at the bottom of the snap staircase.
Twist clockwise until tight. (Figure 19 & 20)
6. To install asymmetric film or diffuser film, follow the
steps 1 to 5 with Asymmetry setup. (Figure 18 & 21)
7 . To install optic and media/film assembly to module
Finished Assembly
Completed Assembly