Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Hold down the wireless activation button for about
6 seconds until the wireless activation lamp blinks in red
(about twice per one second).
5.
When the wireless activation lamp starts blinking
in red, release your finger from the wireless activation
button. Thereafter, hold down the wireless activation
button again for about 6 seconds.
6.
When the wireless activation lamp starts blinking
fast (about 5 times per one second) in red, release your
finger from the wireless activation button. When the
wireless activation lamp lights up in red and later lights
off, all tool registrations are erased.
NOTE: If the wireless activation lamp does not blink
in red, press the wireless activation button briefly and
try again.
Description of the wireless activation lamp status
1
2
Fig.34
► 1. Wireless activation button 2. Wireless activation
lamp
The wireless activation lamp shows the status of the wireless activation function. Refer to the below table for the
meaning of the lamp status.
Status
Color
Standby
Blue
Tool
Green
registration
Cancelling/
Red
erasing
(slow: 2 times/sec.)
tool
registration
Others
Red
Off
Wireless activation lamp
Duration
(approximate)
On
Blinking
Cleaner: con-
Tool: 2 hours
When the tool is
running.
20 seconds
2 seconds
20 seconds
When the
wireless acti-
(fast: 5 times/sec.)
vation button is
pressed down.
2 seconds
3 seconds
-
Waiting for the tool registration or the wireless activation function
tinuing
is available.
The lamp on the cleaner blinks when the stand-by switch is set in
AUTO. The lamp on the tool blinks when the wireless activation
button is pushed. The lamp on the tool will automatically turn off
when no operation is performed for 2 hours.
The wireless activation of the cleaner is available and the tool is
running.
Ready for the tool registration. Searching the tool to be registered.
The tool registration has been finished. The wireless activation
lamp will start blinking in blue.
Ready for the cancellation of the tool registration. Searching the
tool to be cancelled.
Ready to erase all tool registrations.
The tool registration has been cancelled/erased. The wireless
activation lamp will start blinking in blue.
The power is supplied to the wireless unit and the wireless activa-
tion function is starting up.
-
The stand-by switch is not set to "AUTO".
17 ENGLISH
Description
Publicidad
