Publicidad
Idiomas disponibles
Idiomas disponibles
LED WORK LIGHT
your tool has a built-in leD work light (6-fig 1) to illuminate
the work area. when you turn on the tool, the work light will
automatically turn on.
ELECTRIC BRAKE
this drill is equipped with an electric brake. like the torque
settings, an electric brake provides you with another
element of control during various operations. if the tool
consistently fails to quickly stop after the trigger switch
is released, have a qualified serviceman examine the tool.
CHUCK (FIG 5)
• your drill is equipped with a keyless single-sleeve metal
ratcheting chuck (1), so you can quickly change bits
with no extra tools required.
• to insert or change bits, put the reversing switch in the
off (middle) position. rotate the chuck body counter-
clockwise to open the chuck jaws (1a) to a point where
the opening is slightly larger than the bit size you intend
to use. insert the bit. tighten the chuck jaws by rotating
the chuck body clockwise to secure the bit in place.
NOTE:
always make sure that bits are seated firmly
between the chuck jaws. never attempt to operate a bit
that is wobbly, unstable, or broken.
• to remove bits, place the reversing switch in the off
(middle) position. loosen the chuck jaws by rotating the
chuck body counter-clockwise. remove the bit.
GENERAL SCREWDRIVING
1.
Clamp your workpiece.
2.
Drill pilot holes for larger screws or when driving screws
into hardwoods.
3.
exert enough pressure to start the screw and keep it
turning. Do not force the screw. let the tool do the work.
4.
use a speed that will not strip the screw head or break
the screw. Maintain your balance.
GENERAL DRILLING
1.
Clamp your workpiece. use the drill mode (
exert enough pressure to start the drill bit and keep
drilling. Do not force or stall the bit. Do not bend or twist
the bit. let the tool and the drill bit do the work.
2.
Maintain your balance and be prepared for binding and
for bit breakthrough.
OPERATION
1
1a
WARNING:
inserted straight into the chuck jaws. Do not insert the
drill bit into the chuck jaws at an angle and tighten.
this could cause the drill bit to be thrown from the drill,
resulting in possible serious personal injury.
CLUTCH (TORQUE) SETTINGS
• During screw driving applications, you can adjust the
maximum torque that the drill will produce.
• this feature can be used to prevent the stripping and
breaking of screws, or to set a series of screws to a
depth that fits your project.
• set the clutch ring (3-fig 1) to settings from 1 (lightest)
to 22 (heaviest). Drill mode (
is not limited) and used primarily for drilling operations.
• in general, you will find the lower settings more useful
with smaller screws and the higher settings more useful
for larger screws.
APPLICATIONS
WARNING:
twisting the bit, or failure to maintain balance in case of
binding and breakthrough can result in serious personal
injury.
3.
Chattering or vibration may indicate you need a finer
bit or higher speed. if the bit overheats or clogs, it may
indicate you need a coarser bit or slower speed setting.
replace bits when they become dull. Dull bits will
produce poor results and may overheat the drill.
4.
use a coating of light oil when drilling into metal to help
) then
cool the bit, increase drilling action and extend drill bit
life.
ENGLISH
LOOSEN
TIGHTEN
Make sure the drill bit is
forcing a drill bit, bending or
FIG 5
) is direct drive (torque
Publicidad
