LD Systems ANNY 10 Manual De Usuario página 19

The LD ANNY 10 speaker can be operated in mono or stereo mode. In mono mode, a stereo signal
applied to a stereo input or transmitted via Bluetooth is internally summed to mono. If two ANNY 10
speakers are connected wirelessly using the TWS function, the system paired with the Bluetooth input
device becomes the main unit (stereo left) and the stereo extension becomes the follower unit
(stereo right). This means that all stereo signals transmitted via Bluetooth are also reproduced in stereo
without having to connect both speakers by cable. To connect via TWS, simply activate TWS in both units
(LINK), the connection is now automatic and LINKED (= connected) is displayed in the Bluetooth menu.
NOTE:
• Only audio signals played on a paired Bluetooth playback device can be transmitted via the stereo
link function TWS. Audio signals that are present at a physical input are not transmitted via TWS.
• After switching the ANNY 10 speakers off and on again, both the connection to the Bluetooth playback
device and the connection of the speakers via TWS take place automatically.
AUDIO SETTINGS (AUDIO)
Press the rotary-push encoder to enter the main menu and then select the AUDIO menu item by
turning the encoder (dark background). Press the encoder again to enter the submenu and select the
desired submenu item by turning the encoder. Confirm by pressing the encoder. Refer to the following
table for information on the submenu items. Select •MAIN MENU in the submenu and press the encoder
to return to the main menu, select •HOME in the main menu, confirm by pressing the encoder, and then
return to the main display. After about 10 seconds of inactivity, the main display is automatically shown.
19