Levenhuk Wezzer PRO LP310 Guia Del Usuario página 11

• 12-hour/24-hour time format
Pressing MODE switches to time format selection mode. Pressing TEMP/+ or WIND/− changes the time format
(12-hour or 24-hour).
• Setting the date and time
Pressing MODE switches to date and time setting mode. Pressing TEMP/+ or WIND/− is used to adjust the hour.
Further pressing MODE switches to the minute setting. Further pressing MODE switches to the year setting,
then month, then day. TEMP/+ and WIND/− are used to change these settings.
• Pressure
Pressing MODE switches to the pressure unit setting mode. Pressing TEMP/+ or WIND/− selects
the absolute/relative pressure unit (hPa, mmHg, inHg).
Pressing MODE switches to relative pressure calibration mode. Pressing TEMP/+ or WIND/− increases
or decreases relative pressure.
The pressure graph is displayed to the left of the barometric pressure and shows the difference between
the daily average pressure and the 30-day average pressure (in hPa).
To determine the relative pressure for your location, find an official weather station near you (the best real-
time source is weather.com or wunderground.com) and set your weather station to match the official station.
• Temperature
Pressing MODE switches to the temperature unit setting mode. Pressing TEMP/+ or WIND/− selects
the temperature unit (°F or °C).
Every 60 seconds the device measures the temperature, humidity and pressure in the room. If the
temperature is below the minimum range or above the maximum range, the device displays "− −.−".
• Wind
Pressing MODE switches to the wind speed unit setting mode. Pressing TEMP/+ or WIND/− selects wind speed
unit (km/h, mph, knots, m/s, Beaufort rating (bft)).
• Precipitation
Pressing MODE switches to the wind speed unit setting mode. Pressing TEMP/+ or WIND/− selects
the precipitation unit (inches or mm).
In RAIN mode, press RAIN/PRE to view inch/hour, event, hourly, daily, weekly, monthly, and annual
precipitation.
The sensor transmits data on wind speed, wind direction and precipitation every 16 seconds.
Pressing MODE further exits the setup mode.
Alarm mode
Press MODE 3 times to display the upper alarm thresholds.
To adjust the upper thresholds, hold MODE for 2 seconds.
Pressing TEMP/+ or WIND/− increases and decreases the threshold values.
Press MODE to save the selected values and show the alarm system lower thresholds.
To adjust lower thresholds, hold MODE for 2 seconds.
To exit threshold setting mode, press LIGHT.
Alarm mode setup
Hold MODE for 2 seconds to enter alarm mode setup. Press TEMP/+ or WIND/− to adjust alarm settings. Press
MODE to confirm and move to the next item. Press RAIN/PRE to turn the alarm on/off. When the notification
is turned on, the icon will appear.
11