Publicidad
Idiomas disponibles
Idiomas disponibles
Wind speed sensor installation
Place the wind speed sensor (1) onto the shaft. Tighten the fastening screw. Make sure the wind speed sensor
spins freely.
Rain gauge installation
Install the rain gauge (4) and rotate it clockwise to fix it to the outdoor sensor.
Batteries installation
Insert 2 AA batteries into the battery compartment (8). The LED indicator (10) on the back of the transmitter
blinks every 16 seconds (sensor data transmission refresh period).
ATTENTION! If the LED does not light up or stays on, make sure the batteries are inserted properly
and the device is reset correctly. Incorrect installation of batteries may cause permanent damage
to the outdoor sensor.
ATTENTION! In cold climates, we recommend using 1.5V lithium batteries. Alkaline batteries are
suitable for most climates. We do not recommend using rechargeable batteries due to their low
voltage, instability in a wide temperature range, and short service life, which leads to poor signal
reception.
Mounting the assembled multisensor
Attach the multisensor to the prepared 2.5−5.0cm diameter pipe using U-bolts (7).
Align the multisensor in the west direction by rotating it on the mounting pipe. The WEST arrow, located
at the top of the multisensor next to the UV/light sensor (6), should point due west. Use a compass for fine
adjustments.
Once correctly oriented, tighten the bolts.
7
Publicidad
