Publicidad
Idiomas disponibles
Idiomas disponibles
Then insert 2 AA batteries. Make sure the display shows the correct channel number and temperature units.
Recommendations for improving wireless connectivity
To avoid radio frequency interference, we recommend that you adhere to the following conditions.
•
Place the console several meters away from computer monitors and TVs.
•
If you have devices on the 433MHz frequency and are experiencing intermittent connectivity, please
unplug them to troubleshoot.
•
The maximum range of the device is 100m without, and 30m with obstacles.
•
The radio signal does not pass through metal. With metal siding, place the sensor and console so that
there is a window between them.
Table of materials and their effect on radio signal transmission loss
Material
Glass (untreated)
Plastic
Wood
Brick
Concrete
Metal
Display console
Open the battery compartment on the back of the console and insert 2 AA batteries into the display console.
To establish a connection with the multisensor, move the console to a distance of 1.5 to 3m and wait a few
minutes for synchronization.
For precise measurement of temperature and humidity indoors, place the console antenna straight up.
Initial display console setup
Insert batteries into the display console.
The device will display the software version number for 2 seconds.
The console will then turn on all LCD segments for 3 seconds and begin recording the external channel for
3 minutes.
1 − temperature measurement units (°F/°C)
2 − temperature
3 − channel number
4 − relative humidity
Radio signal transmission loss
5−15%
10−15%
10−40%
10−40%
40−80%
90−100%
9
Publicidad
