Levenhuk Wezzer PRO LP310 Guia Del Usuario página 8

ATTENTION! Use the bubble level (6) next to the rain gauge (5) to ensure the multisensor is level.
Reset button and transmitter LED
If the multisensor is not transmitting data, perform a reset. Press and hold RESET for 3 seconds.
Then, re-sync with the console by turning the console off and on. Stay about 3m away from the multisensor.
Additional sensors (1−8)
This device supports up to 8 additional thermohydrometers. Readings will display on the console and
transmitted to Ecowitt.net (data transmission needs to be set up at ecowitt.net through the console).
ATTENTION! Do not use rechargeable batteries. For outdoor use of the sensor in temperatures
between −20°C and 60°C, alkaline batteries are recommended, and lithium batteries are
recommended for temperatures between −40°C and 60°C.
To access the battery compartment on the back of the sensors, slide the compartment cover down.
Before installing batteries, locate the switches on the sensor cover.
For each channel, slide switch 1, 2, or 3 to the up position.
To change °F to °C, slide switch 4 to the up position.
Switch in the down position. Switch in the up position.
8