Taurus CITRUS COMPACT Instrucciones De Uso página 5

EN English (Original instructions)
CITRUS JUICER
CITRUS COMPACT
DESCRIPTION
A Cone
B Pulp filter
C Motor body
D Juice deposit
If the model of your appliance does not have the
accessories described above, they can also be bought
separately from the Technical Assistance Service.
USE AND CARE
• Fully extend the appliance's supply cord before each use.
• Do not use the appliance if its accessories are not
properly fitted.
• Do not use the appliance if the accessories attached to it
are defective. Replace them immediately.
• Do not move the appliance while in use.
• Do not use the appliance if it is tipped up and do not turn
it over.
• Do not turn the appliance over while it is in use or
connected to the mains.
• Store this appliance out of reach of children and/or
persons with physical, sensory or reduced mental or lack
of experience and knowledge.
• Keep the appliance in good condition. Check that the
moving parts are not misaligned or jammed and make
sure there are no broken parts or anomalies that may
prevent the appliance from operating correctly.
INSTRUCTIONS FOR USE
BEFORE USE
• Make sure that all product's packaging has been
removed.
• Please read carefully the "Safety advice and warnings"
booklet before first use.
• Before using the product for the first time, clean the
parts that will come into contact with juice in the manner
described in the «Cleaning» section.
USE
• Extend the supply cord completely before plugging it in.
• Connect the appliance to the mains.
• Cut the citrus fruits to be squeezed in half.
• Turn on the appliance by pushing down on the piece of
citrus fruit, once it has been placed on the juicing cone.
• To avoid a fierce start up, the appliance is turned on
progressively.
• To stop the appliance, simply stop applying pressure to
the cone.
• Empty the juice deposit, pouring its contents into the
glass or container of your choice when it is finished.
• Remark: If you process a large quantity of fruit, you must
periodically clean the filter and remove the remains of
the pulp.
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Unplug the appliance from the mains.
• Put the supply cord back in the supply cord housing.
• The supply cord housing means you can remove and
have available the required length of supply cord for
working with the appliance, preventing accident risk
situations.
• Clean the appliance.
SUPPLY CORD HOUSING
• This juicer has a storage design, the cone, the pulp filter
and motor body, upside down, fit inside the juice deposit.
(Fig.1)
• This appliance has the possibility to storage the supply
cord inside the juice deposit.
CLEANING
• Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
• Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
• Never immerse the appliance in water or any other liquid
or place it under running water.
• It is advisable to clean the appliance regularly and
remove any food remains.
• If the appliance is not in good condition of cleanliness, its
surface may degrade and inexorably affect the duration
of the appliance's useful life and could become unsafe
to use.