HT Instruments HT7051 Manual De Instrucciones página 61

6 MANAGEMENT OF MEMORY DATA
6.1 SAVE MEASUREMENTS
1. After performing a measurement, press
the SAVE key. The display shows a
screen similar to that reported here to
the side, which contains:
• The number of the memory location
in which the measure will be saved
• The last set value for parameter P
2. Should you desire to change the value of parameter P, press the arrow keys to set
the desired value (from 1 to 255). This value helps remembering the location in
which the measurement considered has been performed.
Confirm measure saving by pressing the SAVE key or press the ESC/RECALL MEM
3.
key to go back to the previous screen without saving data in the memory
6.2 DELETE MEASUREMENTS
1. Press the ESC/RECALL MEM key. The
display shows a screen similar to that
reported here to the side, which
contains:
• The number of the last memory
location used
• The value of parameter P
2. Press the FUNC/ERASE MEM key; the
instrument displays a screen similar to
that reported here to the side, which
shows the word "LAST", to indicate that
the last measure saved will be deleted
3. Press the arrow keys; the instrument
displays a screen similar to that
reported here to the side, which shows
the word "ALL", to indicate that all the
measures saved will be deleted.
4. Confirm deletion by pressing the FUNC/ERASE MEM key or press the
ESC/RECALL MEM key to go back to the previous screen without deleting data
EN - 25
HT7051 - HT7051N