Graco SNUGLITE i-SIZE R129 Manual Del Usuario página 33

IMPORTANT
HU
READ THESE INSTRUCTIONS
CAREFULLY BEFORE USE AND KEEP
THEM FOR FUTURE REFERENCE.
YOUR CHILD'S SAFETY MAY BE
AFFECTED IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS.
WARNING:
IMPORTANT, RETAIN FOR FUTURE
REFERENCE: READ CAREFULLY.
For the complete information
and best protection of using the
enhanced child restraints, you must
follow their instruction manuals
carefully:
Please refer to SNUGLITE™ i-SIZE R129
instruction manual for the use of
Snuglite™ ISOFIX base.
Product
Information
On the base with the i-Size ISOFIX
connections
1.This is an "i-Size" Enhanced Child
Restraint System. It is approved
according to UN Regulation
No.129, for use in, i-Size compatible
vehicle seating positions as
indicated by vehicle manufacturers
in the vehicle users' manual.
2.If in doubt, consult either the
Enhanced Child Restraint System
manufacturer or the retailer.
Please refer to the infant carrier
instruction manual for using infant
carrier.
Materials Plastics, Metal, Fabrics
Patent No. Patents pending
Installation
Concerns
1 5
See images -
Installation
with base
ISOFIX Installation
6 16
See images -
Unfold the load leg from storage
compartment. 6
Fit the ISOFIX guides with the ISOFIX
anchor points. 7 The ISOFIX guides
can protect the surface of the vehicle
seat from being torn. They can also
guide the ISOFIX connectors.
Rotate the ISOFIX connectors 180
degrees until they are pointing in the
direction of the ISOFIX guides.
Line up the ISOFIX connectors with
the ISOFIX guides, and then click
both ISOFIX connectors into the
ISOFIX anchor points. 9
! Make sure that both ISOFIX
connectors are securely
attached to their ISOFIX anchor
points. There should be two
63
audible clicks and the colors
of the indicators on the both
ISOFIX connectors should be
completely green.
! Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
After placing the base on the vehicle
seat, extend the load leg to floor,
When the load leg indicator shows
green means it is installed correctly,
red means it is installed incorrectly.
10
-3
! The load leg has 24 positions.
When the load leg indicator
shows red this means the load
leg is in the wrong position.
! Make sure the load leg is in full
contact with the vehicle floor
pan.
! Squeeze the load leg releasing
button, then shorten the load
leg upwards.
! Always make sure the support
load leg has direct contact
with the floor and is in locked
8
position even when the child is
not in it.
The completely assembled base is
shown as
11
! The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points.
! The load leg must be installed
correctly with green indicator.
11
-2
Push the infant carrier module down
9
-1
into the base
12
infant child restraint is secure, the
enhanced infant child restraint
indicator shows green.
! Pull up on the infant carrier
module to be sure it is securely
10
latched into the base.
To release the infant carrier, pull
the infant carrier up
squeezing the infant carrier release
14
button. -1
To remove the base, press the
secondary lock button
and then the button
ISOFIX connectors before removing
the base from the vehicle seat.
Press the ISOFIX releasing button to
fold the ISOFIX. 16
11
-1
64
, if the enhanced
13
14
-2 while
15
-1 first
15
-2 on the
15