SOMFY V 500 PRO io Manual De Instalación página 56

EN
[5]. Clip the monitor to the mounting support, sliding it gently
downwards until the support brackets are well inserted into
the monitor's slots.
3.3 Switching the installation on
After installation, reconnect the monitor mains power units
to their power socket, or reactivate the current.
Important: The power plug must be installed close to the
monitor and must be easily accessible.
When switched on, the blue LED above the screen flashes for
a few seconds before the step-by-step configuration process
is displayed on the screen.
Follow the instructions to configure the additional monitor.
NB: You need to define it as the slave monitor once it is
connected (cf. monitor interface > my personal settings >
general settings > monitor: master/slave).
4 - REPLACING A MONITOR
Switch the power supply off.
[1]. Unhook the monitor being replaced from its mounting
bracket by sliding it upwards.
[2]. Mark the connectors so that they can be reconnected in
the same order on the new monitor:
5-1 5-2 5-3
- + M- M+ M- M+
[3]. Disconnect the connectors of the monitor being replaced
by pulling them upwards slightly.
[4]. Remove the cables from their locations by pulling them
slightly upwards without forcing the connectors.
6
Copyright © 2022 SOMFY ACTIVITES SA. All rights reserved.