Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Prepare Air Conditioner for Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
1.
Unpack the Air Conditioner
Remove Packaging Materials:
Gently handle the air conditioner while unpacking the unit.
Remove tape and glue residue from surfaces before turning
ON the air conditioner. Rub a small amount of liquid dish soap
and dry.
products can damage the surface of the air conditioner.
Dispose of/recycle packaging materials in an appropriate way.
2.
Removal of the Old Grille
NOTE: Single intake grille must be removed when used with the
dual intake Through The Wall (TTW) unit.
Single intake grille
IMPORTANT: While removing the old grille, please hold it to
prevent it from falling.
While holding the grille by the leash with one hand, the retaining
screws can be removed and the grille can be brought inside
through the front of the sleeve as shown below.
3.
Installation of the New Grill
New Dual Intake Grille
Left Intake
NOTES:
This unit´s increased performance characteristics are the result
of having two rear intakes.
It is very important that installation instructions are followed
If there is an existing sleeve and rear grille, check whether the
dimensions are correct, otherwise replace them.
Existing Sleeves may have older single-sided intake grilles.
Single-sided intake grilles must be replaced with the dual intake
Remove the existing grille and save the mounting screws.
Place the grille included with the new air conditioner towards
the inside rear of the sleeve.
Attach the new grille by aligning the four mounting holes.
Re-insert the self-tapping screws into the nylon retainers.
Right Intake
Publicidad
