Publicidad
EN
8
MAINTENANCE
This section describes how to maintain the battery,
battery charger, and product.
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU DO ANY
MAINTENANCE WORK.
Before you do maintenance:
• Stop the product.
• Remove the battery.
• Allow the motor to cool.
• Use correct clothing, protective gloves, and safety
glasses.
8.1
EXAMINE THE BATTERY AND THE
BATTERY CHARGER
Carefully inspect the battery, battery charger, and
connection cord of the battery charger for any signs
of damage, such as cracks or broken parts. Replace if
necessary.
8.2
CLEAN THE PRODUCT, THE BATTERY,
AND THE BATTERY CHARGER
• Clean the product after each use with a moist cloth
and neutral detergent.
• Do not use strong detergents or solvents like "glass
cleaner" to clean the plastic parts or handles.
• Keep the trimmer head free from grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor.
• Do not spray water on the motor and electrical
components.
WARNING
English
• Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
• Prior to inserting the battery into the battery charger,
ensure that the terminals on both the battery and the
battery charger are clean.
8.3
REPLACE THE CUTTING LINE
Note: Do not put more than 1/8 " (3.0mm) of cutting
line in at a time.
1.
1. Prepare a 26.8-inch (680 mm) strip of nylon
cutting line with a diameter of 1/8 inches (3.0
mm).
2.
Remove any leftover cutting line from the trimmer
head.
3.
Feed the cutting line through the hole and push it
until it exits the opposite hole.
4.
Ensure the length is equal on both sides then
wrap around the winding rod as shown in the
figure.
9
TRANSPORTATION, STORAGE, AND
DISPOSAL
9.1
TRANSPORTATION AND STORAGE
• Follow special packaging and labeling requirements
for commercial transportation, including by third
parties and forwarding agents.
10
= 1/8 in.
26.8 in.
(3.0 mm)
(680 mm)
Publicidad
