How to replace the Unit
•
Please consult your dealer for
purchase of a replacement
Unit.
•
Use only the Unit designed for
this product.
1.
Remove the claw of Unit Holder ( 1 ),
and remove the Unit ( 2 ).
2.
Attach the New Unit.
• When the Unit has been replaced with a new part,
the timer will be reset and return to 19,000 hours.
Disposal of the Unit
Please dispose of the used Unit according to the
local disposal laws and regulations.
Materials:
Polybutylene Terephthalate, electronic parts
UZ-C90M
(1 unit)
EN-24
TROUBLESHOOTING
Before calling for service, please review
•
the Troubleshooting list below, since
the problem may not be the product
malfunction.
ABOUT THE PRODUCT
Odour and smoke persists.
• Check the filters. If they appear to be extremely
dirty, clean or replace them.
Air discharged from the product has an
odour.
• Check to see if the filters are extremely dirty.
• Clean or replace the filters.
• Use only fresh tap water. Using other water
sources risks the growth of mold, fungi, or
bacteria.
The product does not operate when
cigarette smoke is in the air.
• Make sure the product is installed in a location in
which the sensors can detect cigarette smoke.
• Check to see if the Sensitive Dust Sensor
openings are blocked or clogged. If they are
blocked or clogged, clean the Sensor Filter or the
Back Panel.
Smell from a new product and/or filter.
• Immediately after removing the plastic bag, a
slight odour may occur. This odour is not harmful
for filter performance or human exposure.
The product makes a clicking or ticking
sound.
• The product may make clicking or ticking sounds
when it is generating ions.
The Cleanliness Indicator is blue even
when the air is not clean.
• The air may have been dirty when the product
was plugged in. Unplug the product, wait one
minute, and then plug the product in again.
The Cleanliness Indicator is red even
when the air is clean.
• Dirty or clogged Sensitive Dust Sensor openings
interfere with sensor operation. Gently clean the
Sensor Filter or the Back Panel.