Sharp UA-KIN52E Manual Del Usuario página 27

The Cleanliness Indicator changes colour
frequently.
• The Cleanliness Indicator automatically changes
colour when the Sensitive Dust Sensor and Odour
Sensor detect impurities. If you are concerned
about the change, you can change sensor
sensitivity. (Page 14, 15)
Filter Maintenance Lamp is on.
• Whenever after performing maintenance or
replacing the Humidifying Filter, connect the
power cord to an outlet and then press the Filter
Reset Button for more than 3 seconds.
(Page 19)
The Display goes off.
• When the Light Control is set to "Auto", the light
automatically turns off when the room is dark or
operating in sleep mode. Moreover, when the
Light Control is set to "OFF", the light is always
off.
If you do not want the light to be off, set the Light
Control to the "Dim" setting. (Page 14, 15)
The Display does not match weather
report or another hygrometre or
thermometre in the room.
• Outdoor and indoor as well as the home
environment (the volume of traffic nearby, number
of stories in home, etc.) may cause a reading
different than those data.
• There is a difference in the level within the same
room.
The Humidify Indicator on the Display
does not light up when the Water Tank is
empty.
• The room has reached the appropriate level of
humidity and has stopped humidifying.
• Check the Humidifier Float for impurities. Clean
the Humidifying Tray. Make sure that the product
is on a level surface.
The water level in the Water Tank does not
decrease or decreases slowly.
• Check to see if the Humidifying Tray and Water
Tank are correctly installed.
• Check the Humidifying Filter. If the filter is
extremely dirty, clean or replace it.
is displayed.
• Make sure that the Humidifying Filter, Humidifying
Tray and Roller are properly installed, and then
turn the power to ON again.
is displayed.
• Make sure the Plasmacluster Ion Generating Unit
inserted properly.
Pull out the Plasmacluster Ion Generating Unit
and insert it to the end again, and then carry out
the operation again.
One of the following is displayed.
• Unplug the product, wait one minute, and then
plug the product in again.
ABOUT THE Wi-Fi
FUNCTION
Wi-Fi connection of the air purifier and the
router cannot be performed.
• Check the specifications of the router in use.
• Adjust the router and antenna direction, move the
router and antenna closer, and so on. After that,
reswitch to turn on the router and perform the
INITIAL SET UP again.
The connection between the air purifier
and your smart device cannot be
established.
• Are the air purifier and your smart device
connecting to the same router?
Connect the air purifier and your smart device
to the same router.
If you still can't connect, try connecting your
smart device to the 2.4GHz band of the router.
• Is the total number of smart devices being in use
exceeding the maximum number for registration
on one air purifier?
The maximum number of smart devices that
can be registered on one air purifier is 10.
• Is the total number of products (air conditioners,
air purifiers, etc.) to be registered with one smart
device exceeding the maximum designated
number?
The maximum number of products to be
registered with one smart device is 30.
EN-25