Publicidad
Idiomas disponibles
Idiomas disponibles
3. ASSEMBLY
Installation of the mounting bracket
Fig. 2 key:
A
Concrete ceiling
B
Wooden ceiling
1.
Drill a ø8 mm hole in the ceiling and insert the bolt. Align the mounting bracket with the
hole and tighten it with the nut.
2.
Remove the clevis pin and clevis from the downrod. Fig. 3
3.
Slide the downrod through the canopy and the coupling cover. Fig. 4
4.
Pass the fan wires and the earth wire through the downrod. Fig. 5
5.
Loosen the screws of the downrod bracket and then place the downrod in its bracket.
Align the holes in the clevis pin of the downrod with the holes in the bracket. Make sure to
insert the straight part of the clevis pin through the hole in the end of the clevis pin and
press until the crimped part snaps into position. Fig. 6.
6.
Finally, retighten the screws.
WARNING
It is very important that the downrod bracket clevis pin is correctly installed and that the
screws are tightened securely. If the pin, clevis or screws are not correctly positioned, the fan
may fall down.
Installing the blades
7.
Remove the motor screws and set them aside to use them in the next step. Fig. 7
8.
Place the blades on the bracket and fix them using the screws. Place the blade bracket on
the motor assembly. Next, tighten the screws. Fig. 8
Installing the decorative cover
9.
Place the decorative cover on the fan motor. Fix it securely by turning it counterclockwise.
Fig. 9
Hanging the fan
Fig. 10 key:
1.
Clip
2.
Slot
3.
Mounting bracket
10. Lift the fan carefully and install the downrod and hanging ball into the mounting bracket
attached to the ceiling. Make sure that the groove in the hanging ball is properly aligned
with the tab on the mounting bracket.
ENERGYSILENCE AERO 5200 PALM
ENGLISH
45
Publicidad
