Publicidad
Idiomas disponibles
Idiomas disponibles
3. Ceiling Fan Assembly
3.11
Reinstall the Hanger Ball on the Downrod as follows:
Route the Five 80-inch Motor Wires through the Hanger
Ball and slide the Hanger Ball over the Downrod
(Figure 11).
Position the Pin through the two holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 11).
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball.
NOTE: A loose set screw could create fan wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the set screw securely tightened. Failure
to verify that the pin and set screw are properly
installed could result in the fan falling.
3.12
The Fan comes with Blue, White, Grey, Red, and
Yellow Wires that are 80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball / Downrod
Assembly (Figure 12).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
You have now partially completed the assembly of
your new Ceiling Fan, proceed to "How to Hang Your
Ceiling Fan". Final Assembly of the Ceiling Fan will be
completed once Ceiling Fan is Hung and Wired.
(Continued)
PIN
HANGER BALL
DOWNROD
Figure 11
6 TO 9
INCHES
1/2
INCH
DOWNROD
Figure 12
9
SET SCREW
GREY WIRE
BLUE WIRE
WHITE WIRE
RED WIRE
YELLOW WIRE
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF315
Publicidad
