Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1
INSTALL WALL BRACKET
• The wall mounted accessories (1) works best if secured to a wall stud or cross brace within the wall,
using the SCREWS (2) supplied.
• If the WALL MOUNTED ACCESSORIES (1) are to be installed on a tile or plaster wall the ANCHORS (4)
and SCREWS (2) should be used.
• Determine desired height and location (optional) and mark a center line. IMPORTANT: The *center
line for the MOUNTING PLATE (3) must be level or the wall accessory will not mount level.
Using the MOUNTING PLATE (3) as a template mark the two spots for the ANCHORS (4). If MOUNTING
PLATE (3) is secured to a stud or cross brace drill small pilot holes for SCREWS (2).
• For installations on drywall or tiled walls: Use ANCHORS (4) and SCREWS (2) for securing
MOUNTING PLATE (3) to finished wall. Drill two 1/4" dia. holes a minimum of 1-3/4" deep. Insert
the two ANCHORS (4) flush with face of the finished wall.
• Secure MOUNTING PLATE (3) to wall with SCREWS (2).
• Install WALL MOUNTED ACCESSORY (1) onto installed MOUNTING PLATE (3). Push WALL MOUNTED
ACCESSORY (1) flush against finished wall and tighten SET SCREW (5) with HEX WRENCH (6) supplied
with accessory.
FINISHED WALL
2
Robe Hook
3
OPTIONAL TO
FINISHED FLOOR
4
A
Note: Installation is typical
for all wall mounted
accessories.
1
Tissue Holder
4
3
2
USE MOUNTING PLATE
AS TEMPLATE
1
Towel Ring
1
5
6
Publicidad
