Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Dishwasher Connection
4.9 Secure the Dishwasher
Center the dishwasher in the opening.
1.
If using the Top Mount, and screw the 1/2" (12.7mm)
2.
wood screws through the holes in the mounting
brackets. Choose the bracket hole best suited for your
installation.
If the dishwasher came with a protective barrier, screw
through the barrier.
For Side Mount, lift the flap on the deco strip and insert
3.
the 1/2" (12.7mm) wood screws underneath.
12
x
=
x
5 Dishwasher Connection
Dishwasher Connection
Follow these instructions to connect the dishwasher.
Dishwasher Connection
5.1 Installing the Water Inlet Connection
The hot water heater should be set to deliver
approximately 120° F (49° C) water to the dishwasher.
Water that is too hot can cause some detergents to lose
effectiveness. Lower water temperatures will increase run
times. The hot water supply pressure must be between 15
- 145 psi (1 - 10 bar).
WARNING
Scalding Hazard
Do not perform any work on a pressured hot water line.
▶
Serious injury could result. Only qualified plumbers
should perform plumbing work. Do not attempt any work
on the dishwasher hot water supply plumbing until you
are certain the hot water supply is shut off.
NOTICE:
Soldering plumbing lines
Temperatures required for soldering and sweating will
▶
damage the dishwasher. If plumbing lines are to be
soldered or sweated, keep the heat source at least 6
inches (152.4 mm) away from the dishwasher.
Plumbing codes
Check local plumbing codes for approved plumbing
▶
procedures and accessories. All plumbing should be
done in accordance with national and local codes.
Note
Important notes for water connection:
¡ If using a solder joint instead of a compression fitting,
be sure to complete all solder connections before
connecting the water supply line to the dishwasher.
¡ Use an approved dishwasher water supply line with the
correct fittings for this connection.
¡ If using copper tubing or other material not depicted in
this manual for water supply, defer to a licensed
plumber for proper installation.
¡ Always use appropriate seals when making plumbing
connections.
Flush the incoming water line for approximately 1
1.
minute to clear any foreign material.
Publicidad
