RIDGID R40311 Manual Del Operador página 19

ASSEMBLY
ASSEMBLING THE STAND
See Figures 22 - 24.
TOOLS NEEDED: Adjustable wrench and 13 mm wrenches.
ITEM
Bolt (M8 x 60 mm) .......................................................2
Washer (ID8 x OD13) ...................................................4
Spacer .........................................................................2
Nut (M8) .....................................................................2
Height adjustment pin .................................................4
Outer leg assembly .....................................................1
Inner leg assembly ......................................................1
 Rest the inner leg assembly inside of the outer leg
assembly, so that the legs form an "X". Align holes for
hardware.
 Place spacers in between the holes in the inner and outer
leg assemblies.
 Slide bolts through washers, outer leg assembly, spacers,
and then through the inner leg assembly, as shown. Install
washers and nuts. Tighten securely.
To adjust the height of the stand
 Move each adjustable foot up or down until the hole in
the leg is aligned with one of the holes in the foot.
 Secure the feet in place using height adjustment pins with
bales.
NOTE: Make sure the feet are flat on the ground and
positioned at the same height to ensure stability.
OUTER LEG
ASSEMBLY
WASHER
BOLT
QTY.
INNER LEG
ASSEMBLY
SPACER
NUT
WASHER
Fig. 22
ADJUSTABLE
FOOT
HEIGHT
ADJUSTMENT
PIN
19 — English
Fig. 23
POSITION
HOLE
Fig. 24