RIDGID R40311 Manual Del Operador página 20

ASSEMBLY
SETTING UP THE STAND
See Figures 25 - 26.
WARNING:
To avoid serious personal injury, always make sure
the tile saw is securely mounted to a workbench
or an approved leg stand. NEVER operate the saw
on the floor.
 Place stand on level ground and line up grooves under
the tile saw table with the supports on the stand. Carefully
set the saw onto the stand.
NOTE: It may be easier to fit the saw onto the stand if the
stand is not opened fully. Slightly tilt one end of the saw
as you set it onto the stand. Ease the other end of the
saw down until it sits on the stand and allow the stand
to open as the saw is fully seated.
 Make sure the stand is stable and on level ground before
using the tile saw.
 When the stand is not in use, it may be folded for storage.
CHANNEL
STAND
20 — English
TILE SAW
CHANNEL
BRACE
Fig. 25
Fig. 26