Publicidad
Idiomas disponibles
Idiomas disponibles
2610051969.qxp_IDH182 IWBH182 1/15/19 10:39 AM Page 11
the drill located next to the variable speed
control selector button. The lowest speed
setting is indicated by one green LED light
turned and the hightest setting is indicated by
all three grean LED lights turning on (Fig. 1).
FORWARD/REVERSING
LEVER & TRIGGER LOCK
to help prevent accidental starts and
accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 4). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an "OFF" position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
BUILT IN WORK LIGHT
Your tool is also equipped with three work
lights for better visibility when driving. The
lights turn on when the trigger is pulled or when
the light button at the foot of the drill is
activated. The light will automatically turn off
within 20 second after releasing the trigger or
may be turned off manually by pressing the
light button at the foot of the drill (Fig. 5).
BIT STORAGE AREA
Your tool is equipped with a bit and storage
area that is conveniently located in the handle
base where it is always handy and unlikely to
get lost or misplaced (Fig. 5).
BELT CLIP (Optional Accessory)
When the tool is attached to the belt, position
yourself to avoid entanglement with surrounding
objects. Unexpected entanglement could
cause the tool to fall resulting in injury to the
operator or bystanders.
The optional belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
After tool use, lock
trigger in "OFF" position
Do not change direction
of rotation until the tool
No -Load Speed
Setting 1:
0-1300/min
Setting 2:
0-2000/min
Setting 3:
0-2800/min
FORWARD/REVERSING
LEVER & TRIGGER LOCK
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig. 5).
To use clip, turn tool upside down and attach
to your belt.
FIG. 5
WORK LIGHT
ON/OFF BUTTON
-11-
impact Rate
0-1100/min
0-2600/min
0-3200/min
FIG. 4
BIT AND BIT
STORAGE AREA
BELT CLIP
(Optional Accessory)
Publicidad
