GE Profile 23 Manual Del Propietario E Instalación página 19

Trim kits and decorator panels.
For CustomStgle _"models
Read these instructions completely and carefully.
Before You Begin
Some models ore equipped with trim kits that allow you to install door ponels. You con order
pre-cut block, white, bisque or stainless steel decorator panels from GE Ports end Accessories,
800.626.2002, or you con odd wood ponels to motch your kitchen cobinets.
Panels less than :Z/4" (6 mm) thick
When installing wood panels less then 1/W' (6 mm) thick, you need to create a filler panel, such as 1/8"
cardboard, that will fit between the face of the door and the wood panel, If Uouare installing the pre-cut
decorator panels, pre-cut filler panels are included in the kit, The combinedthickness of the decorator
or wood panel and the filler panel should be 1/4" (6 mm),
Panels 1/4" thick or less
1/4" max
3/4" (:Z9mm) or Raised Panel
A raised panel design screwedor glued to a 1/4" (6 mm) thick backing, or a 3/4" (19 mm) routed board can
be used, The raised portion of the panel must be fabricated to permit clearances of at least 2" (5,1cm) from
the handle side for fingertip clearance.
Panelsthicker than 1/4" (6 mm), up to 3/4" (19 mm) max, will require that the outer 5/16" (8 mm) of panel
perimeter be no thicker than 1/4" (6 mm).
Weight limitations for custom ponds:
Fresh Food38 lbs. (17 kg) max.
FreezerDoor 28 lbs. (13 kg) mex.
Panels thicker than 1/4" (6 mm}
5/16" (8 ram)
1/4" (6 mm} max
3/4"(19rnm)
1/4" {6 ram)
ck Backing
APnP:f rance
fiii[ll
Door
19